![]() ![]() So those messages wouldn't appear the same way. There is a lot to take into consideration. Correct me if I'm wrong but I think you are running the standard version of dolpin and not lr-dolphin. In this guide I will cover the basics of using the steam controller with the Dolphin GameCube and Wii Emulator. This would be present in any emulator whose name starts with lr-* which indicates the libretro version of the emulator. The bar with the controller information is most likely a RetroArch notification. ![]() On all other emulations i notice there is a bar in the bottom when a game starts this tells me the controller is enabled, but with GC/Wii there is no bar If the controller works this way, then you will need to add a udev rule to allow the emulator to have proper access to the controller. If that still doesn't work, try launching the Dolpin GUI with the sudo command in front of it and trying again.Try launching a game directly from the emulator itself instead of through RetroPie and verify if the controller works this way. When you launch the Dolphin GUI, you can set (add) a ROMs directory and the games should show in the list on the main GUI page. Grab your favorite game, open the case Turn on your TV Insert the cart into your console Turn it on and grab your controller HAPPINESS How about travelling.Is this the same controller you use with other emulators and it works fine? It allows mobile gamers to enjoy games for these two consoles in full HD (1080p) with several enhancements: compatibility with all smartphones controllers. To add to the story i use a Wii Pro Controller Indeed on this system I have Xinput2/0/Virtual core pointer (keyboard and mouse) and evdev/0/Logitech Gamepad F310 (controller). I can try to verify that later tonight when I am in front of my system again.ĮDIT: I just checked my setup at work that I forgot I had access to. On my system, the Xinput2/0/Virtual core pointer is my keyboard and touchpad combo I think. I haven't configured an emulated wii remote before but I did previously use a Logitech F710 as a gamecube controller and as long as the input is selected to match your device it should work. When you launch a game, does the runcommand box (grey with text) say it is launching with dolphin-gui ? That's how I run it so it may be necessary. You can confirm your controller settings have 'stuck' by re-opening the GUI and looking at the screens. It sounds like you are doing the setup properly. The buttons do react, and i saved it, but still i am not able to press buttons in a GC or Wiiware game Select Emulate Wii BT, Emulated Wii, Config, select XInput2/0/Virtual core pointer, press all the individual buttons, they do react, i save this as profile sln Select Controllers, select GC standard controller, press configure, select XInput2/0/Virtual core pointer, press all the individual buttons, they do react Said in Controller setup for GameCube in Hi, So I got this piece of software running, ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |